HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 417
Restores the port configuration to default values.
Synopsis
portcfgdefault [slotnumber/]portnumber
Availability
admin
Description
Use this command to reset any special configuration values on a port to their factory defaults. You can
view the current port configuration using the portCfgShow command.
Operands
This command has the following operands:
Examples
To reset a port to factory defaults:
See also
portCfgEPort
portCfgGPort
portCfgLongDistance
portCfgLPort
portCfgPersistentDisable
portCfgPersistentEnable
portCfgShow
portCfgSpeed
portCfgTrunkPort
portCfgDefault
slotnumber Specify the slot number for a Core Switch 2/64 or SAN Director
2/128. For all other switches, this operand is not required. The slot
number must be followed by a slash ( / ) and the port number, so that
each port is represented by both slot number (1 through 4 or 7 through
10) and port number (0 through 15).
The Core Switch 2/64 and SAN Director 2/128 have a total of 10
slots. Slot numbers 5 and 6 are control processor cards; slots 1 through
4 and 7 through 10 are port cards. On each port card, there are 16
ports, counted from the bottom, numbered 0 to 15.
portnumber Specify a port number. Valid values for port number vary, depending
on the switch type. This operand is required.
switch:admin> portcfgdefault 1/3