HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

464 Fabric OS commands
Speed Negotiation States
For a full explanation of the information displayed by this command, refer to the HP StorageWorks Fabric
OS 4.x procedures user guide.
Operands
This command has the following operands:
LF1 Link Failure: NOS Transmit State
LF2 Link Failure: NOS Receive State
OL1 Offline: OLS Transmit State
OL2 Offline: OLS Receive State
OL3 Offline: Wait for OLS State
LIP reason 8001 Retry loop init
8002 Start loop after gaining sync
8003 Restart loop after port reset
8004 LIP when a loop hangs
8005 Restart loop if LIP received when sending out ARB(F0)
8006 LIP when an OPN returns
8007 Restart loop when LIPs received in OLD_PORT AC state
8008 Restart loop if loop not empty but E_Port loopback
8009 LIP as requested by the LINIT ELS received
800a LIP as requested by the LPC ELS received
800b Restart loop for QuickLoop looplet setup
800c Restart loop for QuickLoop looplet re-initialization
INIT Start negotiation
NM Negotiate master
WS Wait for signal
NF Negotiation follow
NC Negotiation complete
count Specify the maximum number of lines to display. Only the most recent
count entries are displayed. This operand is optional.
saved Specify a nonzero value to display the saved port log from the last switch
fault. Refer to upTime for a list of conditions that cause a fault. The
count is ignored when displaying the saved log. This operand is
optional.
portid Specify the area number of port to be displayed. If a port area number is
specified, all other ports on the switch are ignored. This operand is
optional.