HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 489
Operands
This command has the following operands:
Examples
To display the basic set of statistics for a port:
transfer
Number of times the FL_Port entered TRANSFER
state.
opened
Number of times the FL_Port entered OPENED
state.
starve_stop
Loop tenancies stopped due to starvation.
fl_tenancy
Number of times FL_Port had loop tenancy.
nl_tenancy
Number of times NL_Port had loop tenancy.
frame_nozone
Frames rejected due to zone protection.
slotnumber Specify the slot number for a SCore Switch 2/64 or SAN Director 2/128
For all other switches, this operand is not required. The slot number must
be followed by a slash ( / ) and the port number, so that each port is
represented by both slot number (1 through 4 or 7 through 10) and port
number (0 through 15).
The Core Switch 2/64 and SAN Director 2/128 have a total of 10 slots.
Slot numbers 5 and 6 are control processor cards; slots 1 through 4 and
7 through 10 are port cards. On each port card, there are 16 ports,
counted from the bottom, numbered 0 to 15.
portnumber Specify a port number. Valid values for port number vary, depending on
the switch type. This operand is required.
switch:user> portstatsshow 4/15
stat_wtx 494 4-byte words transmitted
stat_wrx 760 4-byte words received
stat_ftx 28 Frames transmitted
stat_frx 32 Frames received
stat_c2_frx 0 Class 2 frames received
stat_c3_frx 32 Class 3 frames received
stat_lc_rx 0 Link control frames received
stat_mc_rx 0 Multicast frames received
stat_mc_to 0 Multicast timeouts
stat_mc_tx 0 Multicast frames transmitted
(continued on next page)