HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

512 Fabric OS commands
Displays QuickLoop information.
Synopsis
qloopshow [pattern][, mode]
Availability
all users
NOTE: This command requires an HP Advanced Zoning license.
Description
Use this command to display QuickLoop configuration information.
If no parameters are specified, all zone configuration information (defined and enabled) is displayed.
Refer to cfgshow for a description of this display.
If a parameter is specified, it is used as a pattern to match QuickLoop names; those that match in the
defined configuration are displayed.
This command changes the Defined Configuration. For the change to be preserved across switch reboots,
it must be saved to flash memory using the cfgsave command. For the change to become effective, an
appropriate zone configuration must be enabled using the cfgenable command.
NOTE: When security is enabled, this command can only be issued from the primary FCS switch.
Use this command only with v3.x systems in the fabric; QuickLoop is not supported in v4.x.
Operands
The following operands re optional:
Examples
To display all QuickLoops beginning with the letter “q”:
qloopShow
pattern Specify a POSIX style expression used to match QuickLoop
names. Patterns can contain the following special characters:
• Question mark “?”, which matches any single character
• Asterisk “*”, which matches any string of characters
• Ranges “[0-9a-f]”, which match any character within the
range
mode Specify 1 to display the contents of RAM, specify 0 to display
the contents of the transaction buffer. The default value is 0.
switch:admin> qloopshow "q*"
qloop: qlp1 10:00:00:60:69:00:60:11
10:00:00:60:69:00:30:02
qloop: qlp2 10:00:00:60:69:00:60:13