HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 581
Sets a temporary password on a remote switch.
Synopsis
sectemppasswdset domain, login_name
Availability
admin
Description
Use this command to set a unique temporary password for a given account on a specific switch in the
fabric. Use the secTempPasswdReset command to remove the temporary password or reboot the
switch.
You can change any password on any switch. To change the password of an account that has higher level
than that of the current user logged in to the primary FCS switch, you must enter the password of the same
level account on the primary FCS switch.
The password setup on the target is not persistent and will be reset to the secure fabric-wide setting when
this target switch is rebooted or when secTempPasswdReset is run on primary FCS switch.
Each switch has four accounts: root, factory, admin, and user. Root and factory accounts are disabled for
non-FCS switches. This command can enable the root or factory account on a non-FCS switch when you
specify a password for those accounts.
The password should between 8 and 40 characters.
NOTE: This command can be issued only from secure mode and only from the primary FCS switch.
Operands
This command has the following operands:
Examples
To set the password on a remote switch with a Domain of 2:
secTempPasswdSet
domain Specify the domain of the switch from which the temporary passwords
are to be removed. This operand is optional.
login_name Specify the name of the login account from which the temporary
password are removed. This operand is optional.
switch:admin> sectemppasswdset 2, "root"
Please provide password of root on primary FCS switch
in order to change this password: ********
Set remote switch root password: ********
Re-enter new password: ********
Account root has been successfully enabled on domain 2