HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 591

Enables or disables modem dial-in to a control processor (CP).

Synopsis

setmodem [-e] | [-d]

Availability

admin

Description

Use this command to enable or disable modem dial-in to a CP on those systems that support modem

dial-in. When modem dial-in is enabled, the user can log in to a CP through a modem, and a modem

attached to the CP accepts the call. When modem dial-in is disabled, the modem attached to the CP does

not accept the call. When entered with no operands, the command displays the currently state of modem

dial-in.

Modem dial-in must be through a Hayes-compatible modem attached to a CP modem serial port. In the

recommended configuration, a separate modem is connected to each modem port of CP0 and CP1.

These modems connect to the telephone outlet through a RJ-11 Y-adapter and standard telephone wire.

When both CP cards are connected to a shared telephone line, callers are automatically dialed in to the

active CP card, which answers on the first ring unless modem dial-in has been disabled. If the active CP

card cannot answer for any reason, the standby CP card answers on the seventh ring and allows the login

to proceed, unless modem dial-in has been disabled.

Refer to the hardware reference manual for your platform for complete modem installation instructions.

Operands

The optional operands are as follows:

Examples

To disable modem dial-in to a CP: