HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)
692 Fabric OS commands
Debugs a trunk link failure.
Synopsis
trunkdebug port1 port2
Availability
admin
Description
Use this command to debug a trunk link failure. This command reports one of the following messages,
based on the trunking properties of the two specified ports:
• Switch does not support trunking
• Trunking license required
• port port_id is not E_Port
• port port_id trunking disabled
• port port_id speed is not 2G or 4G
• port port_id and port port_id are not on same quad
• port port_id and port port_id connect to different switches
• port port_id is not a trunking port due to: E_Port being disabled, or
trunking might be disabled at remote port
• port port_id and port port_id cannot trunk, please check link length to
make sure difference is less than 400m
Operands
This command has the following operands:
Examples
To debug a trunk connection:
trunkDebug
port1 Specify the area number of port 1. Use the switchShow command to view
the area numbers for a port. This operand is required.
port2 Specify the area number of port 2. Use the switchShow command to view
the area numbers for a port. This operand is required.
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together