HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

Fabric OS 5.0.0 diagnostics and system error messages reference guide 119
Severity
INFO
FSSM-1003
Message
Probable cause
The high-availability (HA) state for the active CP is out of synchronization with the HA state of the standby
CP. If the active CP failover occurs when the HA state is out of sync, the failover is disruptive.
Recommended action
If this message was logged as a result of a user-initiated action (such as running the switchReboot
command), then no action is required.
1. Otherwise, issue the haSyncStart command on the active CP and try resynchronizing the HA state.
2. If the HA state does not become synchronized, run the haDump command to diagnose the problem.
Severity
WARNING
FSSM-1004
Message
Probable cause
The active CP and the standby CP are running firmware incompatible with each other. If the active CP
fails, the failover is disruptive.
Recommended action
Run the firmwareDownload command to load compatible firmware on the standby CP. For details on
this command, refer to the HP StorageWorks Fabric OS 4.x command reference guide.
Severity
CRITICAL
timestamp, [FSSM-1003], sequence-number,, WARNING, system-name, HA State
out of sync
timestamp, [FSSM-1004], sequence-number,, CRITICAL, system-name, Active
and the standby CP have incompatible software.