HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

Fabric OS 5.0.0 diagnostics and system error messages reference guide 281
Severity
ERROR
SEC-1002
Message
Probable cause
The receiving switch failed to validate the security database sent from the primary FCS switch.
This can result from the data package being corrupted, the time stamp on the package being out of range
(as a result of replay attack or out-of-sync time service), or the signature verification having failed.
Signature verification failure may be due to an internal error, such as losing the primary public key or an
invalid database. If a switch is in the error state, the database may not be correctly updated for that
switch.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. The error may also be a result of an internal corruption or a hacker attack to the secure
fabric.
Severity
ERROR
SEC-1003
Message
Probable cause
The specified domain number failed to download security data after the specified number of attempts.
The primary switch segmentd the failed switch after 30 tries. The failed switch may have had some
internal error, which caused it to fail to accept the database download.
Recommended action
1. Reset the version stamp on the switch to 0 and then rejoin the switch to the fabric.
2. If the message persists, run supportFtp as needed to set up automatic FTP transfers.
3. Run the supportSave command and contact your switch service provider.
Severity
WARNING
timestamp, [SEC-1002], sequence-number,, ERROR, system-name, Security data
fails: reason-text
timestamp, [SEC-1003], sequence-number,, WARNING, system-name, Fail to
download security data to domain domain-number after number-of-retires
retries