HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

310 Messages
This can occur only when the primary FCS is distributing the security database to the other switches in the
fabric and local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1096
Message
Probable cause
There was a corruption during the distribution of the security database.
This can occur only when the primary FCS is distributing the security database to the other switches in the
fabric and local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1097
Message
Probable cause
The specified policy could not be found.
Recommended action
If the message persists, run supportFtp as needed to set up automatic FTP transfers and then run the
supportSave command and contact your switch service provider.
Severity
ERROR
timestamp, [SEC-1096], sequence-number,, ERROR, system-name, Failed to
delete policy-name. reason-text
timestamp, [SEC-1097], sequence-number,, ERROR, system-name, Cannot find
active-or-defined policy set.