HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

312 Messages
Probable cause
A corruption occurred during the distribution of the security database.
This can occur only when the primary FCS is distributing the security database to the other switches in the
fabric and local validation finds that an error occurred in the security database. This is a rare occurrence.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1101
Message
Probable cause
The security enable failed on the fabric because one or more switches in the fabric were busy.
Recommended action
Verify that the security event was planned. If so, run the secFabricShow command to verify that all
switches in the fabric are in the ready state. When all switches are in the ready state, retry the operation.
Severity
ERROR
SEC-1102
Message
Probable cause
The switch failed to download certificate, security database, or policies.
This can happen when the switch does not get enough resources to complete the operation, the fabric has
not stabilized, or the policy database is an invalid format.
Recommended action
Wait for the fabric to become stable and then retry the operation. If the policy database is in an illegal
format (with configDownload), correct the format and retry the operation.
timestamp, [SEC-1101], sequence-number,, ERROR, system-name, Failed to
enable security on all switches. Please retry later.
timestamp, [SEC-1102], sequence-number,, ERROR, system-name, Fail to
download security-data.