HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

322 Messages
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
switch.
Severity
ERROR
SEC-1138
Message
Probable cause
A non-primary FCS switch received a security database download.
Recommended action
Verify that the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity
INFO
SEC-1139
Message
Probable cause
The receiving switch failed to validate the security database from the primary FCS switch. This message
usually indicates that the data package is corrupted, the tim stamp on the package is out of range as a
result of a replay attack or out-of-sync time service, or the signature verification failed. Signature
verification failure indicates either an internal error (such as losing the primary public key) or an invalid
database. This message may also be the result of an internal corruption or a hacker attack to the secure
fabric.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
switch.
Severity
ERROR
timestamp, [SEC-1138], sequence-number,, INFO, system-name, Security
database download received from Primary FCS.
timestamp, [SEC-1139], sequence-number,, ERROR, system-name, The
RSNMP_POLICY cannot exist without the WSNMP_POLICY.