HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

Fabric OS 5.0.0 diagnostics and system error messages reference guide 329
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
SEC-1167
Message
Probable cause
This failover attempt cannot proceed because another failover is already in progress.
Recommended action
1. Verify that the security event was planned.
2. If the security event was planned, retry the FCS failover after the current failover has completed, if this
switch should become primary FCS.
3. If the security event was not planned, take appropriate action as defined by your enterprise security
policy.
Severity
ERROR
SEC-1168
Message
Probable cause
A corruption occurred during the distribution of the security database. This can occur only when the
primary FCS is distributing the security database to the other switches in the fabric and local validation
finds that an error occurred in the security database. This is a rare occurrence.
Recommended action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity
ERROR
timestamp, [SEC-1167], sequence-number,, ERROR, system-name, Another FCS
failover is in process. Command terminated.
timestamp, [SEC-1168], sequence-number,, ERROR, system-name, Primary FCS
failover is busy. Please retry later.