HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

Fabric OS 5.0.0 diagnostics and system error messages reference guide 61
AUTH-1038
Message
Probable cause
The PKI certificate is not installed properly.
Recommended action
1. Reinstall the PKI certificate using the pkiCreate command.
2. Reinitialize authentication using the portDisable and portEnable commands or the
switchDisable and switchEnable commands.
3. If the message persists, run supportFtp as needed to set up automatic FTP transfers.
4. Run the supportSave command and contact your switch service provider.
Severity
ERROR
Blade error messages
BL-1000
Message
Probable cause
The switch has started initializing the ports. This message occurs only on the HP StorageWorks SAN
Switch 4/32.
Recommended action
No action is required.
Severity
INFO
timestamp, [AUTH-1038], sequence-number,, ERROR, system-name, Failed to
retrieve certificate during authentication-phase: port port-number
timestamp, [BL-1000], sequence-number,, INFO, system-name, Initializing
Ports...