HP StorageWorks Fabric OS 5.0.0 Diagnostics and System Error Messages Reference Guide (AA-RW1SA-TE, May 2005)

Fabric OS 5.0.0 diagnostics and system error messages reference guide 63
BL-1003
Message
Probable cause
A faulty blade in the specified slot number. This message occurs only on the Core Switch 2/64 and SAN
Director 2/128.
Recommended action
1. Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle the
blade.
2. Run the systemVerification command to verify that blade does not have hardware problems.
Refer to the HP StorageWorks Fabric OS 4.x command reference guide for more information on this
command.
3. If the message persists, replace the blade.
Severity
CRITICAL
BL-1004
Message
Probable cause
The specified blade experienced a failure, but was not faulted due to a user setting. This message occurs
only on the Core Switch 2/64 and SAN Director 2/128.
Recommended action
1. Reboot or power cycle the blade, using the slotPowerOff and slotPowerOn commands.
2. Run the systemVerification command to verify that the blade does not have hardware problems.
Refer to the HP StorageWorks Fabric OS 4.x command reference guide for more information on this
command.
3. If the message persists, replace the blade.
Severity
CRITICAL
timestamp, [BL-1003], sequence-number,, CRITICAL, system-name, Faulting
blade in slot slot-number
timestamp, [BL-1004], sequence-number,, CRITICAL, system-name, Suppressing
blade fault in slot slot-number