HP StorageWorks Secure Fabric OS 5.0.0 User Guide (AA-RW1UA-TE, May 2005)

Removing Secure Fabric OS128

Disabling Secure mode

Secure mode is enabled and disabled on a fabric-wide basis and can be enabled and

disabled as often as desired. However, all Secure Fabric OS policies, including the FCS

policy, are deleted each time secure mode is disabled, and must be re-created the next time it

is enabled. The policies can be backed up using the configUpload and configDownload

commands. For more information about these commands, refer to the

StorageWorks

Fabric OS 4.x command reference manual

Secure mode can be disabled only through a sectelnet, Secure Shell, or serial connection to

the primary FCS switch. When secure mode is disabled, all current login sessions are

automatically terminated.

For information about reenabling secure mode, see ”Enabling Secure mode” on page 57.

To disable secure mode, perform the following tasks:

1. From a sectelnet, Secure Shell, or serial session, log in to the primary FCS switch as

admin.

2. Type secModeDisable.

3. Type the password when prompted.

4. Type y to confirm that secure mode should be disabled.

Secure mode is disabled, all

current login

sessions are terminated, and the passwords are

modified as follows:

• On the switches that were FCS switches, the user, admin, factory, and root passwords

remain the same as in secure mode.

• On the switches that were non-FCS switches, the root, factory, and admin passwords

become the same as the non-FCS admin password.

primaryfcs:admin> secmodedisable

Warning!!!

About to disable security.

ARE YOU SURE (yes, y, no, n): [no] y

Committing configuration...done.

Removing Active FMPS...

done

Removing Defined FMPS...

done

Disconnecting current session.