- Hewlett-Packard Desktop PC Owner's Guide

145

Changing Your Workstation’s Hardware Conﬁguration

Installing Additional memory

Perform the following steps to add memory modules to your workstation.

1 Remove the main tray assembly according to the directions in “Removing the

Main Tray Assembly” earlier in this appendix.

2 Use Figure 37 to locate the memory modules on the CPU Assembly.

Figure 37 Memory Module Location

This workstation has 8 memory slots, labeled 0A, 0B through 3A, 3B. The mem-

ory conﬁguration is 32 MB to 512 MB installed in pairs of 16 MB or 32 MB

memory modules.

Memory modules must be installed in pairs of equal capacity.

Always install the largest capacity memory modules in the lowest numbered

memory slots.

For example, if you have a pair of 16 MB memory modules and a pair of 64 MB

memory modules, ﬁrst install the pair of 64 MB memory modules in slots 0A

and 0B, then install the 16 MB modules in slots 1A and 1B.

NOTICE: Memory slots must be ﬁlled in order from 0A and 0B through 3A and 3B.

Rear of Main Tray