HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 2 Printing Tasks 100
Loading the Input Tray
6 Press down on all four corners of the paper
stack to ensure the paper rests flat in the tray,
without bending.
Note
Do not store paper in the free area on the left
side of Tray 4. Serious damage may occur to
Tray 4.
7 Close Tray 4.
8 Make sure that the paper size tab is set
correctly.
Note
See Printing by Type and Size of Paper
on
page 157
to set the type of paper you loaded in
the tray.
If using the Standard Output Bin (face-down bin),
remember to adjust the paper stop guide on the
output bin. See page 104.
7
8
6