HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 2 Printing Tasks 111
Selecting the Output Bin
Note For the types of paper the printer supports, see page 397
). Envelopes,
labels, and transparencies should only be sent to the Face-up Bin.
The stapler is located on the left side of the 5-bin Mailbox with Stapler. The
stapler can staple jobs of 2 to 20 sheets up to 28 lb paper. The stapler bin can
hold a maximum of 350 sheets. Only jobs sent to the stapler bin will be
stapled.
Selecting a Mailbox through the Software
You can select mailboxes through your software application, printer driver, or
from the printer control panel. Otherwise, follow the instructions below for
setting the overall default printer output bin selection. Where and how you
make selections depends on your software application or associated printer
driver. (Some options may only be available through the printer driver.)
8-bin Mailbox FACE UP BIN Face-up Bin
OPTIONAL BIN 1 Mailbox 1-8
In Job Separation, Collator,
and Stacking Modes, if the
Control Panel setting is: Then the physical location is: