HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 3 Advanced Printing Tasks 162
Changing the Variable Fuser Mode
To change the variable fuser mode for a paper type from the control panel:
1 Press M
ENU
repeatedly until PAPER HANDLING MENU appears.
2 Press I
TEM
repeatedly until CONFIGURE FUSER MODE MENU=NO appears.
3 Press - V
ALUE
+ until YES appears.
4 Press S
ELECT
to select the option.
5 Press I
TEM
repeatedly until the desired paper type appears.
6 Press - V
ALUE
+ repeatedly until the desired variable fuser mode appears.
7 Press S
ELECT
to select the variable fuser mode.
8 Press G
O
to exit the menu.
CAUTION If you change the variable fuser mode to HIGH1, HIGH2, or HIGH3, be sure to
change the variable fuser mode back to the NORMAL setting when you are
done printing that job.