HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 3 Advanced Printing Tasks 185
Edge-to-Edge Printing
Edge-to-Edge Printing
This feature provides the user with the ability to print within approximately 2
millimeters of all edges of the page.
An internal-tray calibration page allows the administrator to calibrate each tray.
The calibration page can be printed from each internal tray and the top tray of
an external paper-handling device. The calibration page cannot be printed
from the envelope feeder.
The edge-to-edge print mode is set from the printer driver or the control panel.
It is most common to use the printer driver when printing individual print jobs.
When set from the control panel, the edge-to-edge feature will remain in
edge-to-edge print mode until turned off from the control panel or from a print
job.
To print a calibration page:
1 Make sure that paper is loaded in the desired tray or trays and that the
trays are properly inserted into the printer
2 Press M
ENU
repeatedly until PAPER HANDLING MENU appears.
3 Press I
TEM
repeatedly until CONFIGURE EDGE TO EDGE=NO appears.
Continued on next page.