HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 4 Printer Maintenance 193
Managing the Toner Cartridge
Resetting the HP TonerGauge
After a new toner cartridge is installed, the user must reset the
HP TonerGauge from the control panel. When the top cover is closed after
installing the new toner cartridge, the NEW TONER CARTRIDGE=NO message is
displayed on the control panel for approximately 30 seconds. To reset the
HP TonerGauge:
Note If the NEW TONER CARTRIDGE=NO message is no longer displayed on the
control panel, press M
ENU
repeatedly until CONFIGURATION MENU appears.
When you replace an empty or low toner cartridge, press I
TEM
repeatedly
until NEW TONER CARTRIDGE=NO appears.
1 Press - V
ALUE
+ until YES appears.
2 Press S
ELECT
to save the selection.
3 Press G
O
to exit the menu.