HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 228
Understanding Printer Messages
BAD DUPLEXER
CONNECTION
The duplexer is not connected properly.
Turn the printer off. Re-install the duplexer. Turn the printer back
on.
CHECK FINISHER
DEVICE
alternates with
CLEAR JAM
The finishing device, such as a stapler, has a jam.
Remove jammed paper from the specified location.
Open and close the top cover to clear the message.
Make sure that the finishing device is properly connected.
If the message persists, see the user guide that came with the
device.
CHECK FINISHER
DEVICE
alternates with
FINISHER ALIGN
ERROR
The finisher cannot bind the paper correctly. The paper feeding into
the device is mis-aligned.
Remove any jammed paper. Align the paper properly and reprint
the job if necessary.
If the message persists, see the user guide that came with the
device.
Printer Messages (continued)
Message Explanation or Recommended Action