HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 232
Understanding Printer Messages
EIO n
INITIALIZING
alternates with
DO NOT POWER OFF
Wait for the message to disappear (approximately 5 minutes). If the
printer EIO card is operating correctly and communicating with the
network, this message disappears after approximately one minute
and no action is required.
If the EIO card is unable to communicate with the network, this
message remains for five minutes and then disappears. In this
case the printer is not communicating with the network (even
though the message is no longer present). The problem may be a
bad EIO card, a bad cable or connection on the network, or a
network problem. Contact your network administrator.
EIO n DISK
SPINNING UP
The disk accessory card takes a long time to initialize. The first
parameter is the accessory slot number for this accessory card.
ENV FEEDER LOAD
[TYPE] [SIZE]
Load the requested envelope type and size into the envelope
feeder.
Make sure the envelope size and type are set correctly from the
Paper Handling Menu in the printer’s control panel (page 427
).
Press G
O
if the desired envelope is already loaded in the feeder.
Press - V
ALUE
+ to scroll through the available types and sizes.
Press S
ELECT
to accept the alternate type or size.
Printer Messages (continued)
Message Explanation or Recommended Action