HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 265
Correcting Output Quality Problems
Display is blank and
internal fans are not
running.
Make sure that the printer power is on. Press all the keys to
see if one is stuck; contact your HP service representative if
this does not work.
Printer display is in the
wrong language or
displays unfamiliar
characters.
Reconfigure the control panel display language. See the
getting started guide, or press and hold S
ELECT
while
simultaneously pushing the power switch ON. Hold S
ELECT
until SELECT LANGUAGE appears, then release S
ELECT
. Use
the V
ALUE
- and V
ALUE
+ keys to select the desired language.
Press S
ELECT
to save your selection. Press G
O
. The control
panel display will indicate the printer is ready to use. If the
new language does not appear in the display, you may not
have pressed S
ELECT
to save your new selection.
Blank or Garbled Control Panel Display (continued)
Situation Solution