HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 274
Correcting Output Quality Problems
Printing stops in the
middle of the job.
! Check the control panel display for an error message.
! If you are on a network, make sure the computer is
correctly configured and there is not a network problem
(see your network administrator).
! Check the line voltage to make sure that it is steady and
within printer specifications. (See page 418
.) Turn the
printer off and then back on.
! Check the time-out setting in your network application. You
might need to increase it.
! If you are trying to copy a file to the printer from the DOS
prompt, use the copy command COPY [filename] LPTn
/B printer port, such as LPT1 (where n is the port number).
Note
To output the page, you might have to send a form feed
command from the computer.
Printing is Incomplete or Incorrect (continued)
Situation Solution