HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 276
Correcting Output Quality Problems
Printer draws paper
from the wrong tray.
! Be sure your software application is selecting the correct
paper size or type.
! Make sure that the driver for your software application is
correctly installed, configured, and capable of requesting
the desired paper size and type.
! The size of paper requested is not loaded in the tray
selected. The printer draws paper from the next default
tray that contains the correct size. Load the correct paper
into the tray and make sure the tray is adjusted correctly.
Load the tray with enough paper to complete the print job.
! If you selected the 2000-sheet Input Tray (Tray 4) or the
2 x 500-sheet Input Tray (Tray 4 or 5) and did not turn the
printer off when installing it, the printer does not recognize
it and draws paper from the next default tray source. (Turn
the printer off, then back on, and the printer will recognize
the tray.)
Control panel settings,
such as RESOLUTION or
ORIENTATION, do not work
or are ignored.
Software commands override control panel settings. (See
page 58
for information about how your software works with
control panel settings.)
Printer Ignores Font, Format, or Tray/Bin Selection (continued)
Situation Solution