HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 280
Correcting Output Quality Problems
Problems with Trays 2, 3, and the Optional 2 x 500-sheet Input Tray
(Trays 4 and 5)
Situation Solution
General operation
problems.
For general paper operation information, see Chapter 2,
Printing Tasks
.
Paper jams and paper
feeding problems.
! See Clearing Trays 2 and 3
or Clearing the Optional
2 x 500-sheet Input Trays (4 and 5) earlier in this Chapter.
! Ensure that paper specifications are within recommended
range (page 390
).
! Make sure the paper guides are adjusted properly and are
not skewed (page 93
).
! Perform preventive maintenance if requested by the
printer.
Cannot access Trays 2,
3, or the Optional
2 x 500-sheet Input Tray
(Trays 4 and 5).
! The appropriate paper size and type must be selected
from the software application for the paper size loaded.
! Adjust the tray correctly for the paper size loaded. Check
the Paper Handling Menu for correct type of paper
available (page 427
).