HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 285
Correcting Output Quality Problems
General repeated
stapler jam problems.
! Check to see that the job to be stapled is less than 2 mm
thick.
! Stapler may have some trapped staple wires that are
obstructing the magazine. Remove loose staples and
paper dust from the inside of the stapler (page 222
).
Printer does not
recognize the 5-bin
Mailbox with Stapler.
! Make sure that the 5-bin Mailbox with Stapler has been
configured in the printer driver. See page 62
for more
information on accessing the printer driver.
! Make sure that the cable from the 5-bin Mailbox with
Stapler is plugged into the printer C-link connector. If not,
turn the printer off and plug the cable into the C-link
connector, then turn the printer back on. See page 292
for
cabling configurations.
! Make sure that all bins are properly installed.
! If the printer still does not recognize the 5-bin Mailbox with
Stapler, contact your dealer or authorized HP service
provider.
Problems with the Optional 5-bin Mailbox with Stapler (continued)
Situation Solution