HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 289
Correcting Output Quality Problems
Paper is not going to the
correct output bin.
! Verify that the correct output bin is selected in the printer
driver. For more information on changing printer driver
settings, see the online help.
! The paper does not meet the specifications for the output
bin. See page 392
for more information on paper
specifications.
! If you are trying to send print jobs to an optional multibin
mailbox, verify that the multibin mailbox has been installed
on the printer and in the printer driver. Also verify the
multibin mailbox mode, which will affect the print job
destination.
The multibin mailbox will
not power on.
! Verify that the power cord is firmly plugged into both the
multibin mailbox and the power receptacle. Remove and
reconnect the power cord.
! Make sure that the cable from the multibin mailbox is
plugged into the printer C-link connector. If not, turn the
printer off, plug the cable into the C-link connector, then
turn the printer back on. See page 292
for cabling
configurations.
! Verify that the cables are firmly attached to the printer.
Problems with the Optional 8-bin Mailbox (continued)
Situation Solution