HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 5 Problem Solving 304
Correcting Output Quality Problems
The printer prints only
part of a page or
document.
The connection has been broken during transmission. If you
move the portable device during transmission, the
connection can be broken. IRDA-compliant devices are
designed to recover from temporary connection interruptions.
You have up to 40 seconds to re-establish the connection
(depending on the portable device being used).
The print job has been
properly sent, but the
printer will not print.
If the connection is broken before the entire print job has
been transmitted to the printer (printing has not yet started),
the printer may not print any of the job. Press C
ANCEL
J
OB
to
clear the printer’s memory. Then, reposition the portable
device within the range of operation described in Printing a
Job on page 182, and print the job again.
The FIR status indicator
turns off during
transmission.
The connection might have been broken. Press C
ANCEL
J
OB
to clear the printer’s memory. Then, reposition the portable
device within the range of operation described in Printing a
Job on page 182, and print the job again.
PS print job will not
print.
Check the configuration in the PostScript Tab of Windows:
check that Protocol is set to AppleTalk and Binary Data is not
selected.
HP Fast InfraRed Connect Problems (continued)
Situation Solution