HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 6 HP Digital Copy 358
HP Digital Copy Operating Instructions
Default Configurations
If the HP Digital Copy is idle and unattended for one minute, the HP Digital Copy
settings will return to the default configuration. Press the Reset key on the control panel
to return all of the HP Digital Copy settings to the default configuration.
The setting changes that you make will remain for one minute before they reset to a
default setting. For example, if you walk up to the HP Digital Copy and press the 5 key,
the number of copies selected will be set to five. If you do not make any other setting
changes and do not initiate a job by pressing the Start key within one minute, then the
number of copies selected will automatically return to one.
After a copy job is completed, the current settings will not change until after another
minute expires. This makes it possible to set up the HP Digital Copy settings in a
particular manner only once for a number of jobs.
Note:
The post-job timeout period will be shorter than the idle timeout period.