HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Appendix A Specifications 406
Paper Specifications
Envelopes
Note For best results, use only Tray 1 or the envelope feeder and the Face-up
Bin.
Envelope Construction
Envelope construction is critical. Envelope fold lines can vary considerably, not
only between manufacturers, but also within a box from the same
manufacturer. Successful printing on envelopes depends upon the quality of
the envelopes. When selecting envelopes, consider the following components:
! Weight: See page 395
for supported envelope weight.
! Construction: Prior to printing, envelopes should lie flat with less than
0.25 inch (6 mm) curl and should not contain air. (Envelopes that trap air
may cause problems.)
! Condition: Make sure envelopes are not wrinkled, nicked, or otherwise
damaged.
! Sizes in Tray 1: See page 392
for supported paper sizes.
! Sizes in the optional envelope feeder: See page 395
for supported envelope
sizes.
Continued on next page.