HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Appendix B Control Panel Menus 452
Configuration Menu
RAM DISK=AUTO OFF
ON
AUTO
This item determines how the RAM disk is
configured. This item appears only if there is no
optional hard disk installed and the printer has at
least 12 MB of memory.
OFF: The RAM disk is disabled.
ON: The RAM disk is enabled. Configure the amount
of memory to be used through the following item: RAM
DISK SIZE.
Note
If the setting is changed from OFF to ON or from OFF to
AUTO, the printer will automatically reinitialize when it
becomes idle.
RAM DISK
SIZE=xxxK
0K and up
(This value
depends on
the amount of
installed
memory.)
This item determines the size of the RAM disk. This
item appears if RAM DISK=ON or AUTO.
Press - V
ALUE
+ to change settings by increments of
100.
Note
This setting cannot be changed if RAM DISK=AUTO.
Changing this value will cause the printer to
reinitialize when it becomes idle.
Item Values Explanation