HP LaserJet 8150 Series Printer - User Guide
Table Of Contents
- HP Customer Care
- Contents
- Introduction
- Printer Basics
- Printing Tasks
- Advanced Printing Tasks
- Overview
- Using Features in the Printer Driver
- Different First Page
- Blank Back Page
- Customizing Tray 1 Operation
- Printing by Type and Size of Paper
- Changing the Variable Fuser Mode
- Loading Custom-size Paper
- Job Retention
- Printing with the Optional HP Fast InfraRed Connect
- Edge-to-Edge Printing
- Duplex Registration
- Printer Maintenance
- Problem Solving
- Overview
- Clearing Paper Jams
- Clearing Jams from the Input Tray Areas
- Clearing Jams from the Optional Duplex Printing Accessory
- Clearing Jams from the Top Cover Area
- Clearing Jams from the Output Areas
- Clearing Jams from an Optional HP Output Device
- Clearing Jams from the Stapler (5-bin Mailbox with Stapler)
- Solving Repeated Paper Jams
- Understanding Printer Messages
- Correcting Output Quality Problems
- Checking the Printer’s Configuration
- HP Digital Copy
- Overview
- HP Digital Copy Installation
- HP Digital Copy Operating Instructions
- HP Digital Copy Features and Benefits
- HP Digital Copy Control Panel
- HP Digital Copy Settings
- Loading documents into the Automatic Document Feeder
- Loading documents onto the Flatbed
- Loading documents larger than the Document Board
- Reading a page from a thick book
- Foreign Interface Harness
- Paper Specifications
- Document Quality
- HP Digital Copy Maintenance
- HP Digital Copy Problem Solving
- Service and Support
- Specifications
- Control Panel Menus
- Printer Memory and Expansion
- Printer Commands
- Regulatory Information
- Index
Chapter 2 Printing Tasks 98
Loading the Input Tray
Loading the Optional 2000-sheet Input Tray (Tray 4)
An optional 2000-sheet Input Tray (Tray 4) is available for the printer. The tray
fits under the printer and acts as a base.
Note
To avoid a paper jam, never open the tray while it
is in use.
For paper specifications, see page 390.
1 Slide Tray 4 open until it stops.
2 Pull the front guide out by the blue pin. Place
the guide into the slots in the top and bottom
of the input tray that correspond to the paper
size you are loading and push in the pin.
3 Repeat step 2 to adjust the back guide.
Continued on next page.
1
2
3