HP CM8060/CM8050 Color MFP with Edgeline Technology - Software Technical Reference (external)

Paper size
Change the width and height values by typing numeric strings into the edit boxes in the Paper Size
group box.
Any entry that is greater than the maximum limits of the width and height control is rounded down to
the maximum valid entry, while any entry that is smaller than the minimum limits of the width and
height control is rounded up to the minimum valid entry.
If units are in millimeters, the custom paper-size range minimum is the limit rounded up to the nearest
whole millimeter. The custom paper-size range maximum is the limit rounded down to the nearest
whole millimeter. Any non-numerical entry reverts to the last valid entry. Width and height entries are
validated when the focus has changed.
The resolution of each control is 1 millimeter or 1/10 of an inch, depending on the current
measurement units.
Units
To change measurement units, click one of the options in the Units group box (either Inches or
Millimeters).
Custom width and height control limits
The minimum paper size for the HP CM8060/CM8050 Color MFP with Edgeline Technology is 76.2
x 127 mm (3 x 5 inches) and the maximum is 215.9 x 355.6 mm (8.5 x 14 inches). The following
table summarizes paper size limits for each paper-handling device.
Table 5-1 HP PCL 6 driver custom paper sizes
Tray Dimensions Minimum Maximum
Tray 1 (80-sheet manual feed) Width 76 mm (3.0 inches) 215 mm (8.5 inches)
Height 127 mm (5.0 inches) 356 mm (14.0 inches)
Tray 2 - 4 (500-sheet) Width 148.0 mm (5.83 inches) 215 mm (8.5 inches)
Height 210 mm (8.26 inches) 356 mm (14.0 inches)
Trays 5 (4000-sheet, optional) Width 148.0 mm (5.83 inches) 215 mm (8.5 inches)
Height 210 mm (8.26 inches) 356 mm (14.0 inches)
Duplexing unit Width 148.0 mm (5.83 inches) 215 mm (8.5 inches)
Height 210.0 mm (8.26 inches) 356 mm (14.0 inches)
Paper Source:
The Paper Source: setting specifies the source tray to use for printing a document. The list of source
trays depends on the device accessories that are installed. Any optional source trays that are installed
through the Device Settings tab also appear here.
194
Chapter 5 HP PCL 6, PCL 5, and PS Emulation drivers for MS Windows
ENWW