HP CM8060/CM8050 Color MFP with Edgeline Technology - Software Technical Reference (external)

To share the device, do the following:
1.
Click Start.
2.
Click Settings.
3.
Click Properties (Windows 2000) or Printers or Faxes (Windows XP Professional and
Windows Server 2003) or Printers and Other Hardware Devices (Windows XP Home).
4.
Right-click the device name.
5.
Click Properties.
6.
Click the Sharing tab.
7.
Click the Share this printer button.
8.
Enter a share name.
9.
Click Apply. Then, click OK to close.
Print-ready file printing in UNIX systems
For UNIX systems, any command method that delivers the print-ready file to the device is acceptable,
including the following:
At the command prompt, type cp </home/yourmachine/FILENAME/ dev/parallel>, where
</home/yourmachine/FILENAME> is the location of the print-ready file.
Print-ready file printing by using the LPR command
This direct-printing method is for use in Windows NT 4.0, Windows 2000, Windows XP, and
Windows Server 2003.
Complete the following steps to print a print-ready file by using the LPR command.
1.
Make note of the TCP/IP address on the Embedded Jetdirect page. The HP Embedded Jetdirect
page is the second page of the configuration page printout. To print a configuration page, see
Print the configuration page on page 275.
2.
From a command window, type the following:
lpr -P IPADDRESS -S IPADDRESS -o l FILENAME lpr -S <IPADDRESS> -Pbinps
<FILENAME>
where IPADDRESS can be either the TCP/IP address or the host name of the device, and where
FILENAME is the file name of the print-ready file.
The parameter (-o l) consists of a lowercase "O", not a zero, and a lowercase "L", not the
numeral 1. This parameter sets the transport protocol to binary mode.
3.
The file prints, but no messages appear in the command prompt window.
4. Type exit at the command prompt to close the command window.
288
Chapter 7 Engineering details
ENWW