HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Set the date and time
You can use the Time/Scheduling menu on the device control panel to establish basic date and time
information. However, you can also use the embedded Web server to set the current date and time and
to establish advanced settings for using daylight savings time and to configure the device to synchronize
with a network time server, if one is available.
1. Open the embedded Web server. See
Open the embedded Web server on page 40.
2. Select the Settings tab.
3. Select Date & Time from the menu on the left side of the screen.
4. In the boxes below Current Date, type the current year, select the current month, and type the
current day.
5. In the boxes below Current Time, type the hour and the minutes, and select AM or PM.
6. Click OK to accept the settings.
7. Click Advanced.
8. Select the correct time zone from the drop-down list.
9. Select the correct Date Format.
10. Select a 12 hour or 24 hour Time Format.
11. Click OK.
12. Click Advanced again to configure Daylight Savings Time Settings.
13. If you need to configure Daylight Savings Time Settings, select the box next to Automatically
adjust clock for daylight saving changes, and then click Start Date/End Date.
14. Select the correct options for the Start Date and End Date for daylight savings time in your area.
For example, if daylight savings time starts on the third Sunday of April at 2:00
A . M ., select the
following options for the start date:
●
Occurrence: Third
●
Week Day: Sunday
●
Month: April
●
Hour: 02
15. Next to DST Offset, type the interval, in minutes, to adjust the clock.
16. If you click Use Defaults, the device returns to the default settings for the current time zone.
17. Click OK to accept the settings.
18. On the main Date & Time page, if a network time server is available, select the box next to
Automatically synchronize with a Network Time Server. Then click NTS Settings.
19. If a network time server is detected, its address appears in the box next to Network Time Server
Address. If you want to use a different network time server, you can type a different network
address in this box.
100 Chapter 6 Manage the device ENWW