HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Initial Setup menu
The Initial Setup menu has three sub-menus:
●
Networking and I/O menu
●
Fax Setup menu
●
E-mail Setup menu
NOTE: This menu is also available through the embedded Web server. In the embedded Web server,
select the Settings tab, and then select Configure Device from the menu on the left side of the screen.
See
Use the embedded Web server on page 88.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no
default.
Networking and I/O menu
Table 7-9 Networking and I/O menu
Menu item Sub-menu item Values Description
I/O Timeout Select a value in the range. The
factory default setting is
15 seconds.
I/O timeout refers to the elapsed
time before a print job fails. If the
stream of data that the device
receives for a print job gets
interrupted, this setting indicates
how long the device will wait
before it reports that the job has
failed.
Parallel Input
NOTE: This item appears only
if an EIO accessory is installed.
High Speed No
Yes*
Use the High Speed setting to
configure the speed that the
parallel port uses to
communicate with the host.
Advanced Functions Enabled*
Disabled
Use the Advanced Functions
setting to enable or disable bi-
directional parallel
communication.
Embedded Jetdirect See Table 7-10 Embedded Jetdirect and EIO <X> Jetdirect menus on page 133 for the list of options.
EIO <X> Jetdirect
Table 7-10 Embedded Jetdirect and EIO <X> Jetdirect menus
Menu item Sub-menu item Sub-menu item Values and Description
TCP/IP Enable Off: Disable the TCP/IP protocol.
On*: Enable the TCP/IP protocol.
Host Name An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host name
is NPIxxxxxx, where xxxxxx is the last six digits of the
LAN hardware (MAC) address.
ENWW Initial Setup menu 133