HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Fax Setup menu
NOTE: Use the fax setup wizard to configure fax options if the analog fax accessory is installed. If the
analog fax accessory is not installed, the device can send faxes by using a LAN fax service or Internet
fax service. Use the embedded Web server to configure those services. See
Use the embedded Web
server on page 88.
Table 7-11 Fax Setup menu
Menu item Sub-menu item Sub-menu item Values Description
Fax Setup Wizard Use this wizard to set up
options for sending faxes
if the analog fax accessory
is installed.
For more information, see
Initial fax setup
on page 38.
Required Settings Country/Region Select a value from the
list.
Use this item to change
the required fax settings
that have been setup
using the Fax Setup
Wizard.
Date/Time Type a value.
Fax Header Phone Number
Company Name
Type a value.
PC Fax Send Enabled
Disabled*
Use this feature to enable
or disable PC Fax Send.
PC Fax Send enables
users to send faxes
through the device from
their computers if they
have the correct driver
installed.
Fax Send Settings Fax Dial Volume Off
Low*
High
Use this feature to set the
volume of the tones that
you hear while the device
dials the fax number.
Error Correction Mode Enabled*
Disabled
When error-correction
mode is enabled and an
error occurs during fax
transmission, the device
sends or receives the
error portion again.
JBIG Compression Enabled
Disabled*
The JBIG compression
reduces fax-transmission
time, which can result in
lower phone charges.
However, using JBIG
compression sometimes
causes compatibility
problems with older fax
machines. If this occurs,
turn off the JBIG
compression.
Dialing Mode Tone*
Pulse
Use this feature to specify
either tone or pulse dialing
for outgoing faxes.
140 Chapter 7 Administration menu ENWW