HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Menu item Sub-menu item Sub-menu item Values Description
Redial On Busy The range is between 0
and 9. The factory default
is 3 times.
Type the number of times
the device should attempt
to redial if the line is busy.
Redial On No Answer Never
Once*
Twice
Use this feature to specify
the number of times the
device should attempt to
dial if the recipient fax
number does not answer.
Redial Interval The range is between 1
and 5 minutes. The
factory default is 5
minutes.
Use this feature to specify
the number of minutes
between dialing attempts
if the recipient number is
busy or not answering.
Detect Dial Tone Enabled*
Disabled
Use this feature to specify
whether the device should
check for a dial tone
before sending a fax.
Dialing Prefix Off*
Custom
Use this feature to specify
a prefix number that must
be dialed when sending
faxes from the device. Use
a comma to indicate a
required pause.
Billing Codes Setup Billing codes off*
Billing codes on
When billing codes are
enabled, a prompt
appears that asks the user
to enter the billing code for
an outgoing fax.
This prompt does not
appear if Allow users to
edit billing codes is not
checked.
Minimum Length The range is between 1
and 16 digits. The default
is 1 digit.
Default Billing Code Type a value.
Allow users to edit billing
codes
Billing Code List
Fax Receive Settings Rings To Answer The factory default is 2
rings.
Use this feature to specify
the number of rings that
must occur before the fax
modem answers.
Ring Interval Select a value in the
range.
Use this feature to control
the time, in milliseconds,
between rings for
incoming faxes.
Ringer Volume Off
Low
High
Set the volume of the ring
tone for incoming faxes.
Table 7-11 Fax Setup menu (continued)
ENWW Initial Setup menu 141