HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Troubleshooting menu
NOTE: This menu is also available through the embedded Web server. In the embedded Web server,
select the Settings tab, and then select Configure Device from the menu on the left side of the screen.
See
Use the embedded Web server on page 88.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no
default.
Table 7-14 Troubleshooting menu
Menu item Sub-menu item Values Description
Event Log Use this feature to print a list of
the 1,000 most recent events in
the event log.
Control Panel LEDs Use this feature to make sure the
components of the control panel
are functioning correctly.
Display
Buttons
Touchscreen
Fax T.30 Trace T.30 Report Print*
Cancel
Use this feature to print or
configure the fax T.30 trace
report. T.30 is the standard that
specifies handshaking,
protocols, and error correction
between fax machines.
When to Print Report Never auto print
Print after any fax job
Print after fax send jobs
Print after fax receive jobs
Print after any fax error
Print after send errors only
Print after receive errors only
Fax Transmit Signal Loss A value between 0 and 30
decibels.
Use this feature to set loss levels
to compensate for phone line
signal loss. You should not
modify this setting unless
requested to do so by an HP
service representative because it
could cause the fax to stop
functioning.
Fax V.34 Normal*
Off
Use this feature to disable V.34
modulations if several fax failures
have occurred or if phone line
conditions require it.
150 Chapter 7 Administration menu ENWW