HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

Issue Cause Solution
Printed pages are wet. The tray might be configured for a
different type of paper than the type that
is loaded.
The paper might not meet specifications.
The paper might be too light in weight.
Make sure that the tray is configured for
the correct type of paper.
Use only paper that meets specifications
for this device. See
Supported paper
on page 154.
Use paper that is heavier than 60 g/m
2
(16 lb bond). If the problem continues, try
setting the paper type to Cardstock.
If the problem continues, contact HP.
Pages come out slowly when printing on
large paper (11x17 or A3 size).
To avoid paper jams and reduced print
quality, the device sometimes prints very
slowly onto large-format paper that is
short-grain and weighs less than 120 g/
m² (32 lb).
If the device normally uses 11x17 or A3
size paper that you know is long-grain, or
is at least 120 g/m² (32 lb) in weight, set
the Tray Behavior setting for Grain
Direction 11x17 and A3 to Long-grain
Paper. Do not use this setting for paper
that is short-grain and lighter weight than
120 g/m² (32 lb).
Also, make sure the paper type is
described correctly when the paper tray
is loaded.
Table 16-1 Paper-handling problems (continued)
242 Chapter 16 Solve problems ENWW