HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

CAUTION: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate. The Ringer Equivalence Number
(REN) of this device is 0.7.
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication
of the maximum number of terminals allowed to be connected to a telephone interface. The termination
on an interface may consist of any combination of devices subject only to the requirement that the sum
of the Ringer Equivalence Number of all the devices does not exceed five (5.0). The standard connecting
arrangement code (telephone jack type) for equipment with direct connections to the telephone network
is CA11A.
Telecom statement for New Zealand
General conditions
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no endorsement
of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance
that any item will work correctly in all respects with another item of Telepermitted equipment of a different
make or model, nor does it imply that any product is compatible with all of Telecom's network services.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the equipment (PC) associated with this modem. The associated equipment shall be set to operate
within the following limits for compliance with Telecom's Specification:
For automatically initiated calls to the same number
(a) There shall be no more than 10 call attempts to the same number within any 30 minute period for a
single manual call initiation, and The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next attempt.
For automatically initiated calls to the different numbers
The equipment shall go on-hook for a period of not less than 5 seconds between the end of one attempt
and the beginning of the next attempt.
Auto-answering incoming calls
Incoming calls shall be answered between 3 and 30 seconds of receipt of ringing.
For correct operation of the ringers in each device, the total of the RN's of all devices connected to a
single line at any time should not exceed 5. The RN (Ringer Number) can be found printed on the
Telepermit Label.
Telecom statement for Australia
In Australia, the fax modem must be connected to the Telecommunication Network through a line cord
which meets the requirements of the Technical Standard AS/ACIF S008.
ENWW Telecom statements 273