HP CM8060/CM8050 Color MFP with Edgeline Technology - System Administrator Guide

to use the service with the device. Depending on the service provider, some of these settings might not
be available.
1. In the area for LAN Fax Service Settings, select the name of the LAN Fax service that you are
using. Select the file format that the service uses.
2. Type the path to the LAN Fax folder in the box below Common Folder Path (UNC). UNC paths
follow this format:
\\servername\sharename\foldername
3. Type the correct Windows domain.
4. Type the username and password for the LAN Fax folder.
5. If you are using Novell NDS, type the NDS tree and NDS context information in the appropriate
boxes.
6. Click Verify Folder Access to check whether you have configured access to the folder correctly.
You will be prompted for the username and password for the folder.
7. In the area for Dialing Settings, type the maximum number of times the device should attempt to
try sending the fax if the first attempt is unsuccessful. Also type the number of minutes to wait
between attempts.
8. In the Input Settings area, select whether to receive notification if there are errors sending the file
to the network folder. If you turn on error correction mode, portions of the fax that were not
successfully sent will be sent again.
9. In the area for Output Settings, select the appropriate transmission speed, and select whether to
include a cover page that the LAN fax service provides.
10. Click Apply to save the settings.
Internet Fax setup
When you signed up for the Internet Fax service, the service provider should have given you the
information you need to set up the service. Use that information to configure the service, then follow
these instructions to use the service with the device.
1. In the area for Internet Fax Service Settings, use the information from your service provider to
fill in the boxes for Internet Fax Provider Domain and the T37 Prefix.
2. Type the default e-mail address for the fax account. If you want to use the e-mail address for the
user who is signed in to the device, select the appropriate box.
3. Select the appropriate file format to use for the faxes.
4. If you are using a service in North America, you can preconfigure the area code for outgoing faxes.
This step is optional.
5. Click Apply to save the settings.
ENWW Configure device settings remotely 53