HP CM8060 / CM8050 Color MFP with Edgeline Technology-System Administrator's Guide

注意: 利用者は自分自身で配線を行わないでください。必要に応じて、適切な電気検査機関や電気
技師にお問い合わせください。 このデバイスの REN (Ringer Equivalence Number)0.7す。
注意: 各端末機器の REN (Ringer Equivalence Number) によって、電話回線に接続できる端末の
最大数がわかります。 電話回線につなげる端末は、どのような組み合わせでもかまいませんが、す
べての機器の REN合計数が 5.0 を超えることは許されません。 直接電話ネットワークに接続
る機器の標準的な接続調整コード (電話ジャックのタイプ)CA11A です。
電気通信基準への準拠の宣言 (ニュージーランド)
General conditions
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no
assurance that any item will work correctly in all respects with
another item of Telepermitted equipment of a different make or model, nor does it imply that
any product is compatible with all of Telecom's network services.
Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC)
associated with this modem. The associated equipment shall
be set to operate within the following limits for compliance with Telecom's Specification:
For automatically initiated calls to the same number
(a) There shall be no more than 10 call attempts to the same number within any 30 minute
period for a single manual call
initiation, and The equipment shall go on-hook for a period of
not less than 30 seconds between the end of one attempt and the beginning of the next
attempt.
For automatically initiated calls to the different numbers
The equipment shall go on-hook for a period of not less than 5 seconds between
the end of
one attempt and the beginning of the next attempt.
Auto-answering incoming calls
Incoming calls shall be answered between 3 and 30 seconds of receipt of ringing.
For correct operation of the ringers in each device, the total of the RN's of all devices
connected to a single line at any
time should not exceed 5. The RN (Ringer Number) can be
found printed on the Telepermit Label.
電気通信基準への準拠の宣言 (オーストラリア)
In Australia, the fax modem must be connected to the Telecommunication Network through a
line cord which meets the requirements of the Technical Standard AS/ACIF S008.
日本の通信設定
JAWW
電気通信規格の適合宣言
273