HP CM8060 / CM8050 Color MFP with Edgeline Technology - System Administrator's Guide

situaţii. Reparaţiile echipamentului certificat trebuie să fie coordonate de către un reprezentant
desemnat de furnizor. Reparaţiile sau modificările aduse de utilizator acestui echipament sau
funcţionarea necorespunzătoare a echipamentului pot determina compania de telecomunicaţii să
solicite deconectarea echipamentului. Pentru protecţia proprie, utilizatorii trebuie să se asigure că toate
legăturile de împământare ale instalaţiei de alimentare, ale liniilor telefonice şi ale sistemului de ţevi
metalice pentru apă, dacă există, sunt conectate împreună. Această precauţie este deosebit de
importantă în zonele rurale.
ATENŢIE: Utilizatorii nu trebuie să încerce să realizeze singuri aceste conexiuni, ci trebuie să
contacteze autoritatea competentă pentru inspecţia instalaţiilor electrice sau un electrician, după caz.
Indicele Ringer Equivalence Number (REN - Număr de echivalenţă sonerie) al acestui echipament este
0,7.
Notă: Indicele Ringer Equivalence Number (REN - Număr de echivalenţă sonerie) asignat fiecărui
terminal de telefonie furnizează o indicaţie a numărului maxim de terminale care se pot conecta la o
interfaţă telefonică. La capătul unei interfeţe se poate afla orice combinaţie de echipamente, supuse
numai cerinţei conform căreia suma indicilor REN pentru toate echipamentele să nu depăşească 5.
Codul standard de aranjare a conexiunii (tip mufă de telefon) pentru echipamente cu conexiuni directe
la reţeaua de telefonie este CA11A.
Declaraţie Telecom pentru Noua Zeelandă
General conditions
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no endorsement
of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance
that any item will work correctly in all respects with another item of Telepermitted equipment of a different
make or model, nor does it imply that any product is compatible with all of Telecom's network services.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the equipment (PC) associated with this modem. The associated equipment shall be set to operate
within the following limits for compliance with Telecom's Specification:
For automatically initiated calls to the same number
(a) There shall be no more than 10 call attempts to the same number within any 30 minute period for a
single manual call initiation, and The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next attempt.
For automatically initiated calls to the different numbers
The equipment shall go on-hook for a period of not less than 5 seconds between the end of one attempt
and the beginning of the next attempt.
Auto-answering incoming calls
Incoming calls shall be answered between 3 and 30 seconds of receipt of ringing.
For correct operation of the ringers in each device, the total of the RN's of all devices connected to a
single line at any time should not exceed 5. The RN (Ringer Number) can be found printed on the
Telepermit Label.
Declaraţie Telecom pentru Australia
In Australia, the fax modem must be connected to the Telecommunication Network through a line cord
which meets the requirements of the Technical Standard AS/ACIF S008.
290 Anexa C Declaraţii de conformitate ROWW