HP CM8060/CM8050 Color MFP with Edgeline Technology-System Operator's Guide

하지 않는다는 요건 내에장치들의 결합으구성할 있습니다. 전화 네트워크에 직접 연결된
치에 대한 표준 연결 배열 규칙(전화 잭형)CA11A 입니다.
뉴질랜드 통신
General conditions
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on
the equipment (PC) associated with this modem. The associated equipment shall be set to operate
within the following limits for compliance with Telecom's Specification:
For automatically initiated calls to the same number
(a) There shall be no more than 10 call attempts to the same number within any 30 minute period for
a single manual call initiation, and The equipment shall go on-hook for a period of not less than 30
seconds between the end of one attempt and the beginning of the next attempt.
For automatically initiated calls to the different numbers
The equipment shall go on-hook for a period of not less than 5 seconds between the end of one
attempt and the beginning of the next attempt.
Auto-answering incoming calls
Incoming calls shall be answered between 3 and 30 seconds of receipt of ringing.
For correct operation of the ringers in each device, the total of the RN's of all devices connected to a
single line at any time should not exceed 5. The RN (Ringer Number) can be found printed on the
Telepermit Label.
호주 통신 규정
In Australia, the fax modem must be connected to the Telecommunication Network through a line
cord which meets the requirements of the Technical Standard AS/ACIF S008.
일본 통신 규정
KOWW
통신 규
259