HP Color CM8050 and CM8060 MFP with Edgeline Technology - New Device Configurations for Administrators

Note: Nearly all 11x17 office paper in North America is now long grain.
Daily Maintenance Calibration Configuration
A new feature has been implemented which enables the device to automatically run pen servicing
calibrations everyday at a configurable time. In previous firmware this calibration was executed at
an unscheduled time with a frequency of approximately once per day. The scheduled daily
maintenance functionality was introduced to reduce the occurrences of calibration delays when the
device is being heavily utilized by customers. The calibration takes between 3 to 15 minutes to
complete depending on printhead health.
By default, the scheduled calibration time is 3:00AM. The calibration time can be set by the device
administrator using the control panel, Embedded Web Server or Web Jet Admin. The
recommendation is to select a time when the system will be powered on and is least likely to be used
so that the servicing routines do not interrupt customer usage of the device.
In order for the daily calibration to execute, the device must be powered ON during the time that the
calibration is scheduled. If the device is set to Sleep during this time, it will wake to perform the
maintenance and then go back to sleep per the configured sleep interval. If the device is powered
OFF when the calibration is scheduled to execute, then the calibration will be initiated at the next
opportunity (when the pens go into the capped position after a print job).
If a device is frequently powered off over night, then a different calibration time (not the 3:00 AM
default) should be selected during a time when the device will be powered ON and least likely to be
in use.
Instructions for setting the scheduled Calibration Time:
Control Panel
1. Touch Administration
2. Touch Time/Scheduling
3. Touch Calibration Time
4. Set the time to the desired calibration time
5. Touch Save
Embedded Web Server
1. Select Settings
2. Select Maintenance
3. Set the time to the desired calibration time
4. Select Apply
Web Jet Admin
1. Select Configuration
2. Select Daily Maintenance from the Device Configuration tab
3. Select the check box
4. Set the desired time
5. Select Configure