Setting up and configuring Intel AMT in HP Business Notebooks, Desktops, and Workstations - White Paper

19
Configuring IPv4
Select Wired LAN IPV4 Configuration and then configure the parameters shown in Figure 14.
Figure 14. Configuring the network for IPv4
– DHCP Mode: Enabled (Recommended setting; default)
If DHCP is disabled, complete steps b – f to configure an IPv4 static IP address for Intel AMT.
If DHCP is enabled (recommended), skip to Step 17.
– IPV4 Address: (Network-dependent; default is 0.0.0.0)
Specify the desired static IP address (such as 192.168.0.1). Ensure that each Intel AMT system has a unique IP
address. Multiple systems sharing the same IP address may result in network collisions that would cause the systems
to respond incorrectly.
– Subnet Mask Address: (Network-dependent; default is 255.255.255.0)
– Default Gateway Address: (Network-dependent; default is 0.0.0.0)
– Preferred DNS Address: (Network-dependent; default is 0.0.0.0)
– Alternate DNS Address: (Network-dependent; default is 0.0.0.0)